RE: [sv-bc] assignment to input

Yes. The later post corrected my earlier post.

 

Please focus on the issue at hand. What exactly is your point in all
this?

 

Dave

 

 

________________________________

From: Bresticker, Shalom [mailto:shalom.bresticker@intel.com] 
Sent: Thursday, September 21, 2006 11:36 PM
To: Rich, Dave; sv-bc@server.eda-stds.org
Subject: RE: [sv-bc] assignment to input

 

What you actually wrote in http://www.eda-stds.org/sv-bc/hm/5105.html is


 

module m(input real r);
 
now defaults a wire of type real. Since we do not allow real wires, you
would either have to add the var keyword, or change the data type to one
that is legal for reals.

 

That is different from saying "However, input bit a, or input real a
still does default to a variable since we do not allow these types on
wires."

Sorry for being pedantic, but the difference is important.

 

Shalom

________________________________

From: owner-sv-bc@server.eda.org [mailto:owner-sv-bc@server.eda.org] On
Behalf Of Rich, Dave
Sent: Thursday, September 21, 2006 7:00 PM
To: Bresticker, Shalom; sv-bc@server.eda-stds.org
Subject: RE: [sv-bc] assignment to input

 

Shalom,

 

I said in a later post that that it cannot default to a wire kind as the
sentence you refer to demands.

 

We would have to either:

1.	define all data types as valid for wire kinds
2.	change the default not to be a wire kind for those types not
supported for wire kinds
3.	make it an error (not backwards compatible with all three
previous Accellera standards)
4.	Remove the special default kind for input and inout ports and
have them match the default kinds everywhere else.

 

Dave

 

 

________________________________

From: owner-sv-bc@server.eda.org [mailto:owner-sv-bc@server.eda.org] On
Behalf Of Bresticker, Shalom
Sent: Thursday, September 21, 2006 5:58 AM
To: Rich, Dave; sv-bc@server.eda-stds.org
Subject: RE: [sv-bc] assignment to input

 

Dave,

 

Where do you see that 'input bit a' or 'input real a' defaults to
variable?

 

The only sentence I see says that, "For input and inout ports, if the
port kind is omitted, then the port shall default to a net of net type
wire."

 

Thanks,

Shalom

 

________________________________

From: Rich, Dave [mailto:Dave_Rich@mentor.com] 
Sent: Monday, September 04, 2006 9:07 PM
To: Bresticker, Shalom; sv-bc@server.eda-stds.org
Subject: RE: [sv-bc] assignment to input

 

Prior to IEEE 1800-2005, input logic a, defaulted to a variable, which
meant it could not be coerced to an inout. Now it defaults to a wire of
type logic. 

 

However, input bit a, or input real a still does default to a variable
since we do not allow these types on wires.

 

As I said earlier, I don't like this new default.

 

input a has always defaulted to a wire. Now it defaults to a wire of
type logic.

 

Dave